Tam Valley Depot ~ Micro Servo Bracket Kit ~ B3D001

This bracket is designed to mount underneath the layout and actuate the points with a spring wire. To munt the servo a single screw and gap-filling CA glue (hold in place with a rubber band until dry) is used.  You are free to use this bracket in other creative ways if you feel the need to experiment.  Comes with a piece of foam tape for easy attachment to the layout and two 1/2″ x 4 screws for permanent attachment.  A 4 screw fits snugly in the mounting holes so that when you are under the layout the screws will not fall in your face.  Also comes with a piece of music wire.

Specs

Actuating Wire- .032″ steel music wire. Length – 5″ before assembly; 3″ usable length after assembly (maximum thickness of subroadbed + track height)

Bracket Size – 1 3/16″ wide x 1.0″ deep X 1 3/16″ high

Fits servo size 0,87″ (23mm) wide x .47″ (12mm) deep (SG90, 9g servos).

Minimum mounting clearance under layout – 1.5″

Mounting Screws – 4 x 1/2″ for bracket to layout; 1 screw (comes with servo) for attachment of servo to bracket

Material – PLA plastic

(Optional) Snap Switch – Digi-key EG4542-ND; mounting screw- Micro Fasteners LPP0205 – 2x 5/16″ screw for plastic

Scales – Z to O